The HPV Pass Thru Chamber is an integrated through the wall transfer device for material transfers between different classification rooms where either an air particulate clean up or material surface bio-sterilization is needed before transfer.
The HPV requires a Bioquell vapour generator (typically the Clarus L), to be attached either room side or in a separate technical area. The bio-decontamination chamber can be fully interfaced to room construction with closing fascia panels. The sterilization transfer chamber is delivered completely assembled, pre-wired and tested
The automated process monitors all critical control points of the disinfection cycle. The high level disinfection cycle takes between 40-45 minutes (load dependent). The load will be decontaminated before transfer via a validated 6 log reduction vaporised sporicidal gassing disinfection cycle. The developed cycle is qualified with biological indicator challenges of Geobacillus stearothermphilus.
The disinfection cycle is fully automatic with digital signal exchanges between the chamber PLC and vapour generator PLC to control the automatic configuration changes needed as the cycles phases progress.
Key Features
|
MAL doors are interlocked so that no two MAL doors are open at the same time |
|
|
The hydrogen peroxide vapour disinfection cycle is an automated cycle for high level disinfection of material outer surfaces |
|
|
Full monitoring of alarm conditions |
|
|
|
|
Sterilization process typically under 30°C |
|
|
Thermal printout of cycle |
|
|
No post-processing residue remediation |
|
|
Excellent material compatibility |
|
|
|
|
Chamber temperature probes |
|
Options
|
Electric lifter with height adjustment, transfer system / rack or shelves |
|
|
|
|
Full material handling solutions |
|
>